Interpack ET xtreme Series, Operations Manual & Parts List

Page: 21 / 81

21
R05
S
ET
-U
P
P
ROCEDURES
UUU
Tape Leg Length Adjustment
For safe sealing, the tape leg length has been factory set at 2 ¾ inches (70 mm).
However, the tape leg length can be shortened or increased.
Front Tape Leg
To adjust the tape leg length on the
front panel of the box, refer to
Figure
7-12
of the clutch assembly. Facing
the rear main frame, loosen the two
(2) M6 Flat Head Cap Screws using
a 4 mm hexagonal key.
Move the clutch assembly to bring it
towards the minus (-) sign stamped
on the plate for a shorter tape leg.
Conversely, bring the M6 screw
towards the plus (+) sign for a
longer tape leg. Re-tighten both M6
Flat Head Cap Screws.
To adjust the tape leg length on the trailing
end of the box, both knife arm extension
brackets must be re-positioned in unison.
Unscrew the three (3) M4 Screws on each
knife arm extension using a 2.5 mm
hexagonal key.
For a
UUU
Shorter Tape Leg
UUU
, bring the knife
arm towards the
UUU
front
UUU
of the tape head.
Conversely, for a
UUU
Longer Tape Leg
UUU
, bring
the knife arm Extension towards the
UUU
rear
UUU
of the tape head.
Replace the three (3) M4 screws on each
knife arm extension and tighten.
Once you obtained the required rear tape
leg, secure the screws with Loctatie 222
(purple) threading agent.
Please note that the rear tape leg is
dependent on line speed.
Figure 7-12
Figure 7-13
Rear Tape Leg
CLUTCH
ASSEMBLY
M6 SCREWS
REAR
FRONT