Page 5
INSTALLATION INSTRUCTIONS
Remove
packaging materials
Remove and dispose of/recycle packaging
materials. Remove tape and glue residue
from surfaces before turning on the air
conditioner. Rub a small amount of liquid
dish soap over the adhesive with your
fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing
alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue. These
products can damage the surface of your air
conditioner.
Handle air conditioner gently.
Remove
Chassis
1. Pull down the front panel and remove the filter.
See Fig.1.
2. Lift the front panel upwards to remove and
place to the side.
3. Locate the four front screws and remove.
These screws will need to be re-installed prior to
mounting the air conditioner. See Fig.2
4. After removing the screws, gently pull away
the front panel from the air conditioner cabinet.
You may push metal cabinet side to release the
plastic tabs on each side of front panel. See Fig
3A & 3B.
5. Disconnect the connector plug of the display
panel from the unit. See Fig. 4.
5. Remove the two screws on the top of
the chassis and also on the side by base
if installed. See Fig.5.
6. Hold the cabinet while pulling on the
base of the chassis and carefully
remove the chassis from the cabinet.
7. Add two foam inserts (included) to holes
in top of cabinet where shipping screws
were removed from. See Fig.6.
8.
Your unit may come with internal
packaging. This packaging must be
removed prior to installing the air
conditioner back into the cabinet. See
Fig.7.
