Page 7
2. Measure the distance between the right-hand
side of the cabinet and the inside of the window
channel.
3. Repeat for the left side. Adjust the cabinet
until the distance on each side is the same.
4. Attach the screws to the window sill. (Refer to
below installation Fig. for the model you bought).
Pre-drill holes if needed.
5. Add the bottom rail seal over the screws.
Install the Support Bracket
1. Hold each support bracket flush against the
outside of the window sill. Tighten each bracket
to the bottom of the cabinet as shown below.
Mark the brackets at top lever of the window sill
and then remove.
2. Assemble the sill angle brackets to the
support brackets at the marked position as
shown below. Hand tighten, but not all the way
for any changes that may need to be made later
during installation.
3. Install the support brackets (with sill angle
brackets attached) to the bottom of the cabinet
as shown below.
4. Tighten all 6 bolts securely
.
NOTE
: Make sure the air conditioner is tilted back
about 1 1/4” to 1 5/8” (tilted about 3
º
to 4
º
downward to the outside). After proper
installation, condensate should not drain from
the overflow drain hole during normal use,
correct the slope otherwise. See below.
1/2” long
screws and
locknuts
