Intermec Trakker Antares 2430, User Manual

Page: 79 / 114

nugget
39
Chapter 4— Troubleshooting and Maintaining the Terminal
Trakker Antares 243X Handheld Terminal User’s Manual 65
Problems While Operating the Terminal (continued)
Problem Solution
You scan a reader command, such as
Change Configuration, and nothing
happens. The reader commands are disabled. Scan the Enable Override command
shown here to temporarily enable all of the reader commands. You can
also enable or disable reader commands with the TRAKKER Antares
2400 Menu System. For help, see “Command Processing” in Chapter 6
of the 2400 Family system manual. When you are finished, remember to
disable the override so that your data is not interpreted as a command.
Enable Override
*$+DC3*
*$+DC3*
The terminal displays the Boot Menu. The Boot Menu appears if you just upgraded the firmware on the
terminal and POST failed. Press
1
to boot the terminal. Report the
problem to your supervisor.
If the main battery was removed from the terminal for an extended
period of time, when you replace the main battery, the Boot Menu
appears. Press
1
to boot the terminal and continue working.
For help, see “Booting the Terminal” on page 78.
You scan a reader command, such as
Change Configuration, and nothing
happens. The reader commands are disabled. Scan the Enable Override command
shown here to temporarily enable all of the reader commands. You can
also enable or disable reader commands with the TRAKKER Antares
2400 Menu System. For help, see “Command Processing” in Chapter 6
of the 2400 Family system manual. When you are finished, remember to
disable the override so that your data is not interpreted as a command.
Enable Override
*$+DC3*
*$+DC3*
You scan a valid bar code label to enter
data for your application. The data
decoded by the terminal does not match
the data encoded in the bar code label. The terminal may have decoded the bar code label in a symbology other
than the label’s actual symbology. Try scanning the bar code label again.
Make sure you scan the entire label.
To operate the 243X quickly and efficiently, you should enable only the
bar code symbologies that you are going to scan. If you enable multiple
symbologies, the 243X may, on rare occasions, decode a bar code
according to the wrong symbology and produce erroneous results.
You want to restore the terminal’s default
configuration so that you can reconfigure
the terminal. Scan this bar code label:
Default Configuration
*.+*
*.+*
You can also use the TRAKKER Antares 2400 Menu System. For help,
see “Restoring the Terminal’s Default Configuration” in Chapter 2 of
the 2400 Family system manual.
After you load the default configuration, you may need to set the primary
network communications parameters to communicate with other devices
in the network.