Intermec Trakker Antares 2430, User Manual

Page: 74 / 114

Chapter 3— Operating the Terminal in a Network
60 Trakker Antares 243X Handheld Terminal User’s Manual
• the PC that the authentication server is loaded on is configured with
the current date and time.
• your terminal is configured with the primary network, advanced
network, and radio parameters.
2 Set the User Name and Password parameters.
a
Scan this bar code label to access the TRAKKER Antares 2400 Menu
System:
TRAKKER Antares 2400 Menu System
*..-.*
*..-.*
The Main Menu appears.
b
Choose Configuration Menu > Communications Menu > Radio .
c
Scroll to the 802.1x TTLS screen and set the User Name and
Password parameters.
If you just want to make sure that your terminal can be authenticated,
you can use the default values of “anonymous” and “anonymous.”
However, Intermec recommends that you set your permanent user
name and password to unique values.
3 Exit the menu system and save all changes.
4
Turn the terminal off and then on again. If you have an application
loaded on your terminal, an application screen appears. If you do not
have an application loaded on your terminal, a cursor appears in the top
left corner of the screen. An AUTHENTICATING message appears on
the terminal screen.
Note: The terminal takes up to 60 seconds to authenticate; however,
this process may take longer if there is interference in RF
communications.
When the terminal is authenticated, it emits a low beep and then a high
beep. The application that was running on the terminal, if any, resumes.
If authentication fails, the terminal emits a high beep and then a low
beep. The terminal will wait 60 seconds and restart the authentication
process. For help, see “Problems While Configuring 802.1x Security”
on page 70.
Once you have successfully authenticated your terminal, you need to
configure a unique user name, password, and at least one server certificate
common name. For help, see Chapter 6, “Configuration Command
Reference,” in the 2400 Family system manual.