Intermec MobileLAN power 12, User Manual

Page: 36 / 46

A-6
Power Cord Set
The power cord must be approved for the country in which it is used.
Country Approvals
U.S.A. and
Canada The cord set must be UL-approved and CSA certified.
The minimum specification for the flexible cord is:
No. 18 AWG
Type SV or SJ 3-conductor
The cord set must have a rated current capacity of at
least 10A.
The attachment plug must be an earth-grounding type
with a NEMA 5-15P (15A, 125V) or NEMA 6-15P
(15A, 250V) configuration.
Denmark The supply plug must comply with section 107-2-D1,
standard DK2-1a, or DK2-5a.
Switzerland The supply plug must comply with SEV/ASE 1011.
•
The appliance coupler (the connector to the unit and not the wall
plug) must have a configuration for mating with an
EN60320/IEC320 appliance inlet.
•
The socket outlet must be near the unit and easily accessible. You
can only remove power from the unit by disconnecting the power
cord from the outlet.
•
This unit operates under SELV (Safety Extra Low Voltage)
conditions according to IEC 950. The conditions are only
maintained if the equipment to which it is connected also operates
under SELV conditions.
•
Switzerland only:
The supply plug must comply with SEV/ASE 1011.
•
France and Peru only:
This unit cannot be powered from IT supplies. If your supplies are
of IT type, this unit must be powered by 230V (2P+T) via an
isolation transformer ratio 1:1, with the secondary connection point
labeled Neutral connected directly to earth (ground).
•
U.K. only:
The Power Bridge is covered by Oftel General Approval,
NS/G/12345/J/100003, for indirect connection to a public
telecommunications system. This can only be achieved using the
console port on the unit and an approved modem.
k