Intermec EasyCoder C4, Reference Manual

Page: 29 / 152

Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual 23
Chapter 5—Editing in Form Edit Mode
Place a Combination of Fixed Data and a Counter
The next command line is a text line containing fi xed data and the
counter (C0). The fi rst time this label form is retrieved for printing, the
start value for this counter must be sent to the printer. The printer will
store the value of the counter for this form and automatically continue
to print the next value the next time this form is retrieved. Reset or set to
another value by sending a new start value.
Note: The value of the counter will be kept in the memory
even if another form is retrieved or the printer is switched off.
Command Explanation
A24,312,0,4,1,1,N,"SERIAL#: "C 0
↵
Text line, fi xed data + 1:st counter
Place a Bar Code with Fixed Data and a Counter
Below a Bar Code Command line is used to enter a Code 128 bar code,
containing the fi xed data "S" in combination with the actual counter
value. It is also set for printing the human readable text below the bar
code.
Note: The narrow to wide ratio is not relevant for Code 128.
The printer will use the value for the narrow bar to defi ne the
bar code. (Value 3 for wide bar defi nition is ignored.)
Command Explanation
B280,440,0,1,2,3,96,B,"S"C 0
↵
Bar code, fi xed data + 1:st counter
Place Graphics
The next line writes a graphic named "Intermec" from memory and
positions it on the form.
Command Explanation
GG24,12,"LOGO"
↵
Write graphic from graphics memory
End Programming of this Form
The closing command that fl ags the end of form, see the full program
listing later in this chapter.
Command Explanation
FE
↵
Closing command to store form