Intermec EasyCoder C4, Reference Manual

Page: 20 / 152

14 Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual
Chapter 3—Setting Up the Printer
Default Setup
Parameter Command Default Setting
Error/Status Char. eR eR0,0 XOFF/XON-handling
Density
D
10
Character Set I 8 bits, code page 0, country code 001
Top of Form backup
JB/JF
Disabled
/
Enabled
Media feed adjust j 136 dots (at 203.2 dpi)
204 dots (at 300 dpi)
Label Gap Sensor O Normal (blockage of light = label)
Label Taken Sensor O Enabled
Ribbon End Sensor
O
Enabled (not in pure DT printers)
Cutter (option) O Disabled
Char. substitution
oR
No substitution
Form Length Q Length 1200 dots, gap 24 dots at 203.2 dpi
Length 1200 dots, gap 24 dots at 300 dpi
Label Width q 832 dots (at 203.2 dpi)
1208 dots (at 300 dpi)
Reference Point R X:000;Y000
Reply Character
UC
none
Print Speed S 50 mm/sec. (2 inches/sec.)
Error Handling UN/US Disabled
Windows Mode
W
Disabled
Serial Port Y 9600 baud, no parity, 8 data bits, 1 stop bit
Print Direction
Z
ZT (Start printing at top of image buffer)
Printhead Resolution Measures
203.2 dpi printheads 203.2 dpi (8 dots/mm) in both directions
300 dpi printheads 300 dpi (11.81 dots/mm) across the media path
304.8 dpi (12 dots/mm) along the media path
The setup will be reset to default values if...
• the printer's fi rmware is upgraded using a fi rmware cartridge,
• or the
Feed key is pressed more than 3 seconds in the Dump Mode.