TruVision IP PTZ Camera Configuration Manual
53
2. Select
Enable
to enable the function.
3. Click
Draw Area
, and then draw a rectangle on the image as the designated region.
When you draw the rectangle, all lines should connect end-to-end to each other. Up
to four areas are supported. Click
Clear
to clear the areas you have drawn. The
designated region parameters can be set up separately.
Note:
The area can only be quadrilateral.
4. Choose the region to be configured.
Threshold:
The threshold for the time the objects remain left in the region. If you set
the value as 10, an alarm is triggered after the object is left and remains in the
region for 10 s. The range is between 5 and 100 s.
Sensitivity:
The sensitivity value defines the size of the object that can trigger the
alarm. When the sensitivity is high, a small object can trigger the alarm. The range
is between 1 and 100.
5. Set the arming schedule for the unattended baggage detection. The arming
schedule configuration is the same as that for motion detection. See “Motion
detection alarms” on page 39 for more information.
6. Select the actions to be used for the unattended baggage detection. The options
are:
Notify Surveillance Center
Send an exception or alarm signal to remote management
software when an event occurs.
Send Email
Sends an email to a specified address when there is a motion
detection alarm.
Upload to FTP/Memory
Card/NAS
Capture the image when an alarm is triggered and upload the
picture to NAS or FTP server.
Intelligent Tracking
Triggers the intelligent tracking function
Trigger Recording
Triggers the recording to start in the camera.
