TruVision IP PTZ Camera Configuration Manual
39
Select a predefined preset from the drop-down list (see “PTZ parameters” on page
22 for information on setting up a preset).
Select a period check box and set the start and end time periods as well as the
linked scene. Up to four periods can be configured for a selected preset.
4. To set up the image parameter switch based on scheduled periods, enable
Scheduled-Switch
.
Select a period check box and set the start and end time periods and linked scene.
Up to four scheduled periods can be configured.
5. Click
Save
to save changes.
Note
: The two functions are disabled by default.
Motion detection alarms
You can define motion detection alarms to detect motion when the camera is not
moving. A motion detection alarm refers to an alarm triggered when the camera detects
motion. However, the motion alarm is only triggered if it occurs during a programmed
time schedule.
Select the level of sensitivity to motion as well as the target size so that only objects
that could be of interest can trigger a motion recording. For example, the motion
recording is triggered by the movement of a person but not that of a cat.
You can define the area on screen where the motion is detected, the level of sensitivity
to motion, the schedule when the camera is sensitive to detecting motion as well as
which methods are used to alert you to a motion detection alarm.
You can also enable dynamic analysis for motion. When there is motion, the area will
be highlighted in green.
Defining a motion detection alarm requires the following tasks
Figure 11: Motion detection window
