Interlogix NX-1248E, Instruction Manual

Page: 24 / 27

LCD Keypad
22
DISPLAY DESCRIPTION
Log Full
Log Full The event log is full. Old events will be pushed
out as new ones enter the log.
Open Open Reports user number, date, time and partition of
opening.
Close Close Reports user number, date, time and partition of
closing.
Exit Err Exit Error Entry/Exit zone was faulted at the instant the
exit delay expired.
Rec Close Recent Close An alarm occurred within 5 minutes after the
control was armed.
Autotest Auto Test Sending a communicator test at a specified
interval.
Start Prog Start
Programming Local programming is started.
End Prog
End
Programming Local programming is ended.
Start Dnld Start Download Download session is started.
End Dnld End Download Download session is ended.
Cancel Cancel System is disarmed and the Cancel button was
pressed within 5 minutes of an alarm.
Gnd Flt Ground Fault A short to ground has been detected.
Man Test Manual Test Bell and/or communicator test while system is in
disarmed condition.
Re-exit Re-Exit The exit delay has been re-started without
disarming the system.
Output Trip
Output Trip A trip has occurred on an expander auxiliary
output.
Data Lost Data Lost Communication of a signal has failed (log only
event).
Walk-test
Walk-Test A zone “Walk-Test” mode has been activated.
End Test End Test Test has been ended.
Cross-Trip Cross Trip The first zone of a cross zone has been tripped
(log only).
Expansion
Event Expansion
Event An expansion module created an undefined
event.
Partial Arm Partial Arm Reports a closing in the stay mode.