Interlogix NX-1248E, Instruction Manual

Page: 15 / 27

LCD Keypad
13
4. NOTE: The LCD will now display all of the partitions to which this user has
access. If you wish to remove a partition, press the partition number on the
keypad, and the display will mark that partition with a (-) hyphen indicating
access has been removed. If you wish to re-establish user access to the
partition, press the partition number again.
5. Press [
U
] to save the data. The LCD will then prompt you for the next user
code.
6. If another user code needs to be programmed, return to Step 3. If not, press
[#] to exit this feature without saving the data.
RESET FUNCTION
This function is used to reset Smoke Detectors, Zone Troubles, and Zone
Tampers.
1. Disarm the system if it is not already disarmed.
2. Press [
U
] [7]. Resets have now been performed.
3. If the keypad begins beeping, the reset did not execute properly. Enter your
code to silence the keypad. Wait a few minutes and repeat step 2 to attempt
another reset. If the keypad still beeps after repeated attempts, please
contact your installer.
READING THE EVENT LOG
The control panel has an event log that can be retrieved using a master code.
This log contains a listing of the events along with date, time, and partition where
the event occurred.
1.
To view the log, press [
U
] [9] [0]. The LCD screen will prompt you for a code.
2. Enter your master code. The LCD screen will now show the most recent
event.
3. To view the events from most recent to the oldest, press [
y
].