Interlogix NX-1248E, Instruction Manual

Page: 14 / 27

LCD Keypad
12
3. Enter the user code. Depending on the control panel in your system, this will
be either a 2-digit or 3-digit number. Remember to enter leading zeros, i.e. [0]
[0] [4] for user number 4.
4. The LCD keypad will display the current code for this user. Stars (
U
)
represent blanks. NOTE: To delete a user code, press [
U
]-[
U
]-[
U
]-[
U
] for a 4-
digit code or [
U
]-[
U
]-[
U
]-[
U
]-[
U
]-[
U
] for a 6-digit code.
5. Enter the new user code for that individual. If you are changing the current
code, you may use the up and down scroll keys to select the digit to change
and enter the correct number. If it rejects the code because of duplication or
such, the sounder will beep 3 times.
6. Return to step 3 if another user code needs to be programmed.
7. To exit Code Programming, press [#] while the LCD screen is prompting for a
new user.
ASSIGNING USER CODE AUTHORITY LEVELS
Assign authority levels to users by following the steps below. Assign user codes
before assigning authority levels.
NOTE: You must have authority to the partition you wish to add or remove
from another person’s authority.
1. Press [
U
] [6]. The LCD Screen will now prompt for a code.
2. Enter [master code]. The LCD Screen will prompt for a user number.
3. Enter the user code. Depending on the control panel in your system, this will
be either a 2-digit or 3-digit number. Remember to enter leading zeros, i.e. [0]
[0] [4] for user number 4. The LCD will now prompt you for the attributes in
the following chart.
PROMPT
Outputs used?
ž
DO NOT CHANGE THIS SEGMENT!
Open / Close Rprt?
Bypass enable?
Arm / Disarm?
(These are for use by a professional installer only.)
Master code?
Sched arm only?
Arm only?
Reserved
0=No 1=Yes
Your keypress will apply to the user code you entered in
Step 3.
Output 4 ?
Output 3 ?
Output 2 ?
Output 1?
If these messages appear on the LCD screen, press [
U
]
until you return to the prompt for the user code or until you
exit this adjust mode.