Chapter 4: Web configuration
NS3562-8P-2S User Manual
91
Object
Description
GVRP
Enable
or
Disable
GVRP on this switch.
Join Timeout
The interval between transmitting requests/queries to participate in a
VLAN group.
Range: 20-16375 centiseconds
Default: 20 centiseconds
Leave Timeout
The interval a port waits before leaving a VLAN group. This time
should be set to more than twice the join time. This ensures that after
a Leave or LeaveAll message has been issued, the applicants can
rejoin before the port actually leaves the group.
Range: 45-32760 centiseconds
Default: 60 centiseconds
LeaveAll Timeout
The interval between sending out a LeaveAll query message for
VLAN group participants and the port leaving the group. This interval
should be considerably larger than the Leave Time to minimize the
amount of traffic generated by nodes rejoining the group.
Range: 65-32765 centiseconds;
Default: 1000 centiseconds
Note:
Timer settings must follow this rule: 2 x (join timer) < leave timer < leaveAll
timer
Buttons
• Click
Apply
to apply changes.
GVRP port setting
Configure GVRP port settings on this page.
The page includes the following fields:
Object
Description
Port Select
Select a port from this drop-down menu to assign a protocol VLAN
port.
GVRP Enabled
Enable
or
Disable
on the port.
Registration Mode
By default, GVRP ports are in normal registration mode. These ports
use GVRP join messages from neighboring switches to prune the
VLANs running across the 802.1Q trunk link. If the device on the
other side is not capable of sending GVRP messages, or if you do not
want to allow the switch to prune any of the VLANs, use the fixed