Interlogix IFS NS3550-24T/4S, User Manual

Page: 236 / 498

236
1) Boot from a new masterthe switch,
2) Disable and re-enable Limit Control on the port or the switch,
3) Click the Reopen button.
Trap & Shutdown
: If Limit + 1 MAC addresses is seen on the port, both the "Trap"
and the "Shutdown" actions described above will be taken.

State
This column shows the current state of the port as seen from the Limit Control's
point of view. The state takes one of four values:
Disabled
: Limit Control is either globally disabled or disabled on the port.
Ready
: The limit is not yet reached. This can be shown for all actions.
Limit Reached
: Indicates that the limit is reached on this port. This state can only
be shown if Action is set to
None
or
Trap
.
Shutdown
: Indicates that the port is shut down by the Limit Control module. This
state can only be shown if Action is set to
Shutdown
or
Trap & Shutdown
.

Reopen Button
If a port is shutdown by this module, you may reopen it by clicking this button,
which will only be enabled if this is the case. For other methods, refer to
Shutdown
in the Action section.
Note, that clicking the reopen button causes the page to be refreshed, so
non-committed changes will be lost.
Buttons
: Click to refresh the page. Note that non-committed changes will be lost.
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
4.12.2 Access Management
Configure access management table on this page. The maximum entry number is
16
. If the application's type match any one of
access management entry, it will allow to access the switch. The Access Management Configuration screen is shown in Figure
4-12-2 .
Figure 4-12-2
Access Management Configuration Overview Page Screenshot
The page includes the following fields:
Object Description

Mode
Indicates the access management mode operation. Possible modes are:
Enabled
: Enable access management mode operation.