10
Intergraph Computer Systems recommends that you select the software to install as follows:
If you are installing ISM on....
Select these ISM software components:
A Windows NT monitoring console
Server Manager Console and Server Manager Agents
A Windows 95 monitoring console
Server Manager Console
A Windows NT server you want to
monitor
Server Manager Console, Server Manager Agents,
and EMC Driver
NOTE
The DMI Service Provider (the WIN32SL service) is delivered with InterSite DMI and ISM.
InterSite DMI is installed on the server by Intergraph Computer Systems before shipment.
When you install ISM, you are prompted about overwriting Service Provider files. The
prompt shows the dates of the Service Provider files currently on the server. If the Service
Provider files already on the server are newer than the Service Providers that are installed by
ISM, make sure you do not overwrite the files on the server.
NOTE
If your server is an InterServe 80 or InterServe 800, you cannot install a MIDI device driver.
The MIDI device driver uses the same IRQ setting (IRQ 5) as the EMC.
To install the ISM software:
1. Make sure you are logged onto the computer using an account with Administrator
privileges.
2. Have the Intel registration key handy. The Intel registration key is found on the
Registration and Serial Number card in the Intel software package. You will be asked
for the registration key during installation, and the installation will not complete until
you have entered it.
3. Insert the Intel LANDesk Server Manager CD-ROM into the computer’s CD-ROM
drive. After you insert the CD-ROM, the Setup program starts automatically. You will
use the Setup program to install the ISM software.
4. Follow the instructions on the screen to install the ISM software. Key in the Intel
registration key when prompted.
5. When prompted to select a Console Folder, select InterSite from the Start Menu folder
list. Doing this allows all of the InterSite products to be installed in a common group.
If InterSite is not in the list, select LANDesk Server Manager (this is the default).
6. Remove the CD-ROM from the computer’s CD-ROM drive.
7. Insert the Intergraph SRVMON30 Supplemental diskette into the computer’s floppy disk
drive.
8. The
HOBBPOST
.
TXT FILE
contains the Power On Self Test (POST) codes descriptions
used in the Server POST Code display. The
HOBBSRV
.
HDW
file indicates which EMC
features your server supports, such as the remote temperature probe and the hard reset.