I N S T A L L A T I O N M A N U A L
C I T Y 2 S L I D E ™
7
Rev. 7/15 (SBK-CITY2 INSTL)
STEP TWO:
Handrail Pre-Assembly Procedure
1. Pre-assembled wedge, round to flat con-
nector and carriage bolt as shown in
Diagram K above.
2. Insert the assembly from step 1 above
into the handrail as shown in the Diagram
above by sliding a round to flat connector
into the handrail opening until the Shoulder
portion of the connector seats against the
end of the tubing. The Connector may
have to be tapped into place.
3. With one hand hold the connector tight
inside the handrail while pulling the carriage
bolt away from the handrail locking the
wedge into the connector.
4. Remove the carriage bolt.
5. Repeat steps 1 through 4 on each end of
both handrails.
DIAGRAM K
(NOT TO SCALE)
DIAGRAM L
(NOT TO SCALE)
STEP 2
Insert assembly into handrails as shown, until shoulder
portion of connector seats against end of tubing, tap
connector into place if needed.
STEP 1
Pre-assemble wedge, round-to-flat connector and
carriage bolt as shown.
STEP 3
Hold connector tight inside handrail, then pull bolt away
from handrail to lock wedge into anchor.
STEP 4
Remove carriage bolt and repeat steps 1-3 for each
end of both handrails.
STEP THREE:
Slide Assembly Procedure
1. Slip the two short legs over the 2 aluminum projections
on the underside of the Lower Flume. NOTE: The shorter
of the two legs will go on the projection on the inside of
the flume curve.
2. Using two people and while holding the two legs in place,
turn the slide over.
3. One person must now hold the slide at its normal height
while the second person installs the two long legs and
inserts the ladder (squared end) snugly into the mating
slots on the underside of the Upper Flume. See Diagram
L above.
4. Insert a handrail into the 1-1/16" (2.56 cm) diameter
hole on the top of the slide runway, at the same time
ensure the predrilled holes in both the handrail and ladder
are aligned. See Diagram L above. Install one 7-1/2" (19 cm)
aluminum spacer between the top set of predrilled holes
and secure with a 1/4" x 12" (.64 x 30.5 cm) bolt, flat
washer, lock washer, and 1/4" (.64 cm) nut. Repeat this
process for the second set of holes from the top utilizing
the 5-1/2" spacer and secure with 1/4" x 7-1/2" (.64
x 19 cm) bolt. Secure the bottom of the handrail with a
1/4" x 1-1/2" (.64 x 3.8 cm) hex head bolt.
5. Repeat 1 through 3 for the other handrail.
6. Align flume sections and tighten flume bolts that were
“hand tightened” only in step one. Place protective caps
on bolt heads and nuts.
INSTALLATION MUST MEET ALL NATIONAL & LOCAL BUILDING CODES
