Intense 2022 TAZER MX, Manual

Page: 8 / 44

S T E P 3
INSTALL REAR DERAILLEUR
S T E P 4
INSTALL HANDLEBAR:
PRO BUILD
Remove the zip-tie from the main pivot bolt hole (A) .
Using a 5mm Allen key slowly begin to screw the
rear derailleur into the derailleur hanger/frame until
you have engaged the threads.
It is important that you locate the ‘B Screw’ on the
derailleur and position it correctly so that it sits
on the derailleur hanger notch (B) . Once aligned,
tighten the derailleur and torque to 8-10Nm.
Using the 4mm Allen key remove the four bolts from
the two handlebar clamps of the stem (C) and put
the handlebars in place. Use the guidelines printed
on the handlebars to help position them centrally and
evenly. Check that the brake, shifter and dropper
post cables have a nice flow and are not kinked or
twisted in any way.
Replace the stem handlebar clamps and reinsert the
bolts (D) , first by hand and then with the 4mm Allen
key. Gradually tighten the bolts, making sure that the
bars are still positioned correctly and that the space
between the faceplate and the main body of the
stem is even.
When tightening the bolts follow this pattern (E) to
ensure even clamping: top left, bottom right, bottom
left, top right. Finish off using the torque wrench
to 5Nm.
A
C
B
D
E
15 14