A
B
C
D
S T E P 5
CONNECTING THE
MOTOR MODE SELECTOR
AND DISPLAY WIRES
Included in your accessory box is a special
SHIMANO connector tool (TL-EW300 for the PRO
model and TL-EW02 for the EXPERT). Use this tool
(A)
to connect the wires to your handlebar display.
The tool helps to protect the plug and wire from
damage. Slide the plug and wire into the tool as
shown, ready for connection.
Sitting on your bike, the cable that comes from the
controller (mode selector) on the left-hand side of
your handlebars goes into the first hole nearest to
the stem (left-hand side), port number 1.
(B)
Align
the plug into the port, then apply a small amount of
pressure. There will be an audible click when the
cable is fitted correctly. You may need to loosen and
rotate the Display Selector slightly to help you gain
access to the holes.
The other cable that goes into your frame
(C)
(down
to the drive unit/motor) attaches to the second hole
from the left, port number 2.
NOTE FOR PRO BUILD:
Once the mode selector is
connected correctly you can install the front number
plate
(D)
. The number plate covers over all the cables
except the front brake cable. Secure with supplied zip-
ties. You may want to leave this until after STEP 10A.
19
18
Summary of Contents for 2022 TAZER MX
Page 1: ...2 0 2 2 T A Z E R M X MANUAL...
Page 44: ...2 0 2 2 T A Z E R M X MANUAL...
