S T E P 7
INSTALL
FRONT WHEEL
Just like the rear wheel, remove all packaging from
the front wheel making sure the hub end caps are still
in the correct place and that they haven’t been pulled
off by accident. If they do come off, just press them
back into position. Then remove the brake pad spacer
(usually orange, yellow or red). At this stage be
careful not to pull the front brake lever until the wheel
has been installed. Do not touch the brake rotors with
your hands or gloves as this may contaminate them.
PRO BUILD (ÖHLINS):
With a 5mm Allen key loosen
the pinch bolts on the front lower legs. Then with the
same 5mm Allen key in a counterclockwise direction
remove the front axle
(A)
from the drive-side of the bike
EXPERT BUILD (DVO):
With a 6mm Allen key loosen
in a counterclockwise direction and remove the front
axle from the drive-side of the bike. Note: there are no
pinch bolts on the EXPERT build/DVO fork.
(B)
Position the wheel so that the rotor fits into the
brake caliper body and that the hub body slots into
the grooves on the fork. Once everything is aligned
reinstall front axle.
PRO BUILD:
With a 5mm Allen key, and applying
some inward pressure, tighten the axle
(C)
in a
clockwise direction. Torque to 7Nm, then tighten and
torque the two lower leg pinch bolts
(D)
to 7Nm.
EXPERT BUILD:
With a 6mm Allen key, and applying
some inward pressure, tighten the axle in a clockwise
direction
(E)
. Torque to 7Nm.
C
A
B
D
E
23
22
Summary of Contents for 2022 TAZER MX
Page 1: ...2 0 2 2 T A Z E R M X MANUAL...
Page 44: ...2 0 2 2 T A Z E R M X MANUAL...
