Intel® SRMK2 Internet Server Technical Product Specification
58
system is hung.
5.3 Front Panel LED Indicators
Table 44 defines the LED indicators on the front panel board. The LED’s are numbered below
from 1 through 9 when reading them from in front of the server from left to right.
Table 44: Front panel LEDs (DS1, DS2, DS3, DS4, DS5, DS6, DS7, DS8, DS9)
LED
Description
Power On
(Green)
This LED indicates if the system is powered on. A blinking green LED indicates the
system is in sleep mode.
System Fault
(Amber)
This LED lights when the system has detected a system fault state.
Hard Disk
(Green)
This LED indicates when any access to the hard drive has taken place. It shows
activity from any one of three sources: Hard Disk 1, Hard Disk 2, or an external SCSI
drive that is connected to the internal SCSI activity connector
LAN1 Activity/Link
(Green)
This LED lights when a successful 10/100Mb link has occurred to an Ethernet port.
Once the LED is lit, it blinks at a variable rate to indicate network activity on this
channel.
LAN1 Speed
(Green)
This LED lights when the LAN1 controller has detected and is configured to run at 100
Mbps operation. For 10 Mbps operation, the LED will not be lit.
LAN2 Activity/Link
(Green)
This LED lights when a successful 10/100Mb link has occurred to an Ethernet port.
Once the LED is lit, it blinks at a variable rate to indicate network activity on this
channel.
LAN2 Speed
(Green)
This LED lights when the LAN2 controller has detected and is configured to run at 100
Mbps operation. For 10 Mbps operation, the LED will not be lit.
SCSI HDD #1
Activity (Green)
This LED will light Green to show SCSI HDD #1 activity.
SCSI HDD #0
Activity (Green)
This LED will light Green to show SCSI HDD #0 activity.
5.4 Front Panel I/O Connector
The front panel board is connected to the SRMK2 serverboard through a high-density connector
for I/O information. See Table 36 for Front panel I/O connector (J38) signal definitions.
