Intel SC450NX - Server Platform - 0 MB RAM, Product Manual

Page: 31 / 200

31
3 Configuration Software and Utilities
This chapter describes the Power-on Self Test (POST) and system configuration utilities. The
table below briefly describes the utilities.
Table 6. Configuration Utilities
Utility Description and brief procedure Page
BIOS Setup If the system does not have a diskette drive, or the drive is
disabled or misconfigured, use Setup to enable it.
Or, you can move the CMOS jumper on the system board from the
default setting (Protect CMOS memory) to the Clear setting; this
will allow most system configurations to boot. For the procedure to
do this, see “CMOS Clear Jumper” on page 152. Then run the
SSU to configure the system.
33
Server Setup Utility (SSU) Use for extended system configuration of onboard resources and
add-in boards, viewing the system event log (SEL), setting boot
device priority, or setting system security options.
The SSU can be run from either the configuration software CD or
from a set DOS-bootable diskettes. See the printed
Quick Start
Guide to make a set of SSU diskettes.
Information entered via the SSU overrides information entered via
Setup.
46
Emergency Management
Port (EMP) Console Use to access and monitor the server remotely. 57
FRUSDR Load Utility Use to update the Field Replacement Unit (FRU), Sensor Data
Record (SDR), and Desktop Management Interface (DMI) flash
components. 69
BIOS Update Utility Use to update the BIOS or recover from a corrupted BIOS update. 74
Firmware Update Utility Use to update BMC flash ROM. 76
Symbios SCSI Utility Use to configure or view the settings of the SCSI host adapters
and onboard SCSI devices in the system. 77
Hot Keys
Use the keyboard’s numeric pad to enter numbers and symbols.
Table 7. Hot Keys
To do this: Press these keys
Clear memory and reload the operating
system

this is a system reset.
<Ctrl+Alt+Del>
Secure your system immediately. <Ctrl+Alt>+hotkey (Set your hot-key combination with the
SSU or Setup.)
Enter BIOS Setup during POST BIOS. F2
Abort memory test during BIOS POST. ESC (press while BIOS is updating memory size on screen)