Intel R1304BTLSFAN, Service Manual

Page: 63 / 112

Intel
®
Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide 43
Removing a Hard Disk Drive (R1304BTSSFAN/
R1304BTLSFAN)
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
“Removing the Server
System Cover” on page 28 .
4. Disconnect the power and data cables from the drive.
5. Remove the screws that holds the hard drive bracket to the chassis. Save this screw.
You will use it to reinstall the drive assembly later.
6. Remove the drive carrier from the chassis.
7. Remove the four screws that attach the hard drive to the drive carrier. Lift the drive
from the carrier. Store the drive in an anti-static bag.
8. If you are installing a new drive, skip the rest of these steps and instead see
“Installing and Removing a Hard Drive (R1304BTSSFAN/R1304BTLSFAN)” on
page 41 , beginning with step 7.
9. Insert the screws that held the drive in the carrier into the screw-locations on the
carrier for future use.
10. Set the drive assembly into place in the chassis.
11. Attach the drive assembly to the chassis with the screws that you removed
in Step 5.
Note: You must install the assembly that contains the optical drive bracket at the left side of
the system.
12. Install the server system cover. For instructions, see “Installing the Server System
Cover” on page 29 .