Intel R1304BTLSFAN, Service Manual

Page: 64 / 112

44 Intel
®
Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide
Installing and Removing a Hot-Swap SATA Drive
(R1304BTLSHBN)
You can install up to three hot swappable SATA drives. The HDD0 drive bay is at the left
side. You do not need to install the drives in order; you can install HDD1 before HDD0.
Cautions: If you install less than four drives or devices, the empty drive bays must be occupied by
carriers with baffles to maintain proper system cooling.
Note: The server system does not support all hard drives. See “Server System References” on
page xi for an Internet link to a list of supported hardware.
Installing a Hot-Swap SATA Drive (R1304BTLSHBN)
1. If it is installed, remove the front bezel.
2. Locate the drive position you want to use.
3. Open the latch at the front of the hard drive carrier. See letter "A" in Figure 24.
Figure 24. Removing the Drive Carrier (R1304BTLSHBN)
4. Pull out on the black lever and slide the carrier from the server system.
5. Remove the four screws that attach the plastic retention device or the previously
installed hard drive to the drive carrier. Two screws are at each side of the retention
device or the hard drive. Store the plastic retention device for future use.
6. Remove the hard drive from its wrapper and place it on an antistatic surface.
7. Set any jumpers and/or switches on the drive according to the drive
manufacturer's instructions.
A
B