Intel R1304BTLSFAN, Service Manual

Page: 101 / 112

Intel
®
Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide 81
•
Make sure the driver is loaded and the protocols are bound.
•
Make sure the hub port is configured for the same duplex mode as the network
controller.
•
Make sure the correct networking software is installed.
•
If you are directly connecting two servers (without a hub), you will need a crossover
cable.
•
Check the network controller LEDs next to the NIC connectors.
Problems with Network
The server hangs when the drivers are loaded
•
Certain drivers may require interrupts that are not shared with other PCI drivers. For
these drivers, it may be necessary to alter settings so that interrupts are not shared.
See the documentation that came with your PCI card(s) for information on
changing interrupts.
Diagnostics pass but the connection fails
•
Make sure the network cable is securely attached.
•
Make sure you specify the correct frame type in your NET.CFG file.
•
The controller stopped working when an add-in adapter was installed.
•
Make sure the cable is connected to the port from the onboard network controller.
•
Make sure your BIOS is current. See “Server System References” on page xi for a
link to the current version.
•
Make sure the other adapter supports shared interrupts. Make sure your operating
system supports shared interrupts.
•
Try reseating the add-in adapter.
The add-in adapter stopped working without apparent cause
•
Reseat the adapter.
•
The network driver files may be corrupt or deleted. Delete and then reinstall the
drivers.
•
Run diagnostics.