Intel R1304BTLSFAN, Service Manual

Page: 61 / 112

Intel
®
Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide 41
Installing and Removing a Hard Drive
(R1304BTSSFAN/R1304BTLSFAN)
Caution: The hard drives are NOT hot-swappable. Before removing or replacing a hard drive, you
must first take the server out of service, turn off all peripheral devices connected to the
system, turn off the system by pressing the power button, and unplug the AC power cord
from the system or wall outlet.
You can install up to four SATA drives. The HDD0 drive bay is at the left side of the
chassis. The HDD1 drive bay is at the right side of HDD0. You do not need to install the
drives in order; you can install HDD1, HDD2, or HDD3 before HDD0.
Note: The server system does not support all hard drives. See “Server System References” on
page xi for an Internet link to a list of supported hardware.
Installing a Hard Disk Drive (R1304BTSSFAN/
R1304BTLSFAN)
Note: If you are replacing a hard drive, see “Installing and Removing a Hard Drive
(R1304BTSSFAN/R1304BTLSFAN)” on page 41 for instructions first. Return to these
steps when directed.
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server. Unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
“Removing the Server
System Cover” on page 28 .
4. Locate the drive position you want to use.
5. Remove the screws that holds the hard drive bracket to the chassis. See letter “A” in
Figure 22. Save the screws. You will use them to reinstall the drive assembly later.
6. Slide-out the drive carrier from the chassis. See letter “B” in Figure 22 .