Connecting and Operating Onkyo RI Components
En-61
Setting Item
Default Value
Setting Details
NET
Main/Zone2/Zone3 Set the 12V trigger output setting to each
input.
"Off": No output
"Main": Output when "NET" is selected as
input for main room.
"Zone2": Output when "NET" is selected as
input for ZONE2.
"Main/Zone2": Output when "NET" is selected
as input for main room or ZONE2.
"Zone3": Output when "NET" is selected as
input for ZONE3.
"Main/Zone3": Output when "NET" is selected
as input for main room or ZONE3.
"Zone2/Zone3": Output when "NET" is
selected as input for ZONE2 or ZONE3.
"Main/Zone2/Zone3": Output when "NET" is
selected as input for main room, ZONE2 or
ZONE3.
7. Remote Controller
Setting Item
Default Value
Setting Details
Remote ID
1
Select an ID for the unit's remote controller from
"1", "2", and "3" to prevent interference between
the unit and other Integra/Onkyo components
that are installed in the same room. After
changing the ID on the main unit, change the
ID on the remote controller accordingly with the
following procedure.
1. While holding down RCV, press and hold
Setup for about 3 seconds until the remote
indicator lights.
2. With the number buttons, press one of 1, 2,
and 3. The remote indicator flashes twice.
Remote Mode
–
Input and register the remote controller code of
other devices.
●
For registration of the remote control code,
refer to the next section, "Operating Other
Components with the Remote Controller".
