Functions
MoRoS ADSL 2.1 PRO
In order to establish a connection in leased line mode, it is also
necessary, to enter the IP address or the domain name of the target as
well as the port or the IPT dial number. A secondary destination can be
entered optionally.
In order to establish an outgoing connection via input 2, it is also
necessary, to enter the IP address or the domain name of the target as
well as the port or the IPT dial number. A secondary destination can be
entered optionally. The function itself can be enabled in the menu "In- /
Outputs" on the page "Inputs".
In order to use authentication via TCP or UDP at an INSYS VCom for
outgoing connections, select in the "VCom authentication" section for
"outgoing" either the radio button "UDP" or "TCP". This authentication
will also be used in leased line mode or when establishing a connection
via an input. This setting is ignored if IPT is used.
Save your settings by clicking "OK". The serial Ethernet gateway will be
restarted with this. Existing serial Ethernet gateway connections will be
terminated.
13.6.2
Configuring Serial Ethernet Gateway Interface
The serial Ethernet gateway of the MoRoS ADSL 2.1 PRO allows a comprehensive
configuration of the serial interface and the packing of the data arriving there into
TCP packets. It is also possible to use the Telnet protocol. RFC 2217 is also
supported with this, which allows to modify the serial interface parameters during
the operation via a Telnet connection.
Configuration via the web interface
In order to configure the serial interface speed, select in the menu" Serial
Ethernet" on the page "Interfaces" the speed in the drop-down list
"Speed (in Bit/s)".
Configure the data format of the serial interface in the drop-down lists
"Data bits / Parity bits / Stop bits".
Select the data flow control (Hardware, i.e. RTS/CTS or Software i.e.
XON/XOFF) in the drop-down list "Flow control". If the connected serial
device does not support the respective data flow control, you must not
use this.
In order to use the control lines DCD and DTR, check the checkbox "Use
modem control lines".
In order to reset the control lines after the connection is terminated,
check the checkbox "Reset modem control lines after connection
termination".
82
