MoRoS ADSL 2.1 PRO
Commissioning
Configuring the MoRoS ADSL 2.1 PRO
The device is connected to the PC.
The power supply of the device is enabled.
You have the required access rights to change the IP address of the
network card to which the MoRoS ADSL 2.1 PRO is connected.
1.
Change the IP address of the network card to which the device is
connected to an address that starts with 192.168.1.
As an alternative, you may also configure your network card to
"Automatic address allocation". The integrated DHCP server of the
MoRoS ADSL 2.1 PRO will then allocate an address from the
according address range to your network card.
Do not use the address 192.168.1.1. This is the factory default IP
address of the device. For example, use 192.168.1.2 as IP address for
the network card in your PC.
2.
Open a web browser and enter the URL "http://192.168.1.1" into the
address bar.
The browser loads the start page of the MoRoS ADSL 2.1 PRO.
If you see the message in your browser window that the page with
this address cannot be found, follow the following steps: Check,
whether the device is supplied with power. If yes, most probably a
wrong IP address is configured in the device. Press the reset key three
times within two seconds and repeat this instruction from step 2.
A dialogue will prompt you to enter a user name and password for
authentication.
with the data entered, just reset
times within two seconds and repeat this
instruction from step 2.
You should now see the start page of the web interface.
3.
Enter the user name "insys" and the password "moros".
User name and password are set as factory defaults. If the registratio
at the web interface does not work
the device to the factory defaults.
Press the reset key three
n
The MoRoS ADSL 2.1 PRO is installed successfully and ready for
configuration.
39
