INSTEON LampLinc Dimmer User’s Guide
Page 7 of 21
Unlinking LampLinc Dimmer from an INSTEON Controller
If you are no longer going to use a LampLinc Dimmer that has previously been linked to an INSTEON
Controller, it is very important that you unlink it, because otherwise the controller will retry any commands
intended for the unused module, thus slowing down your system.
1. Select your INSTEON Controller from the list below and follow the method shown to put it into
Unlinking Mode
.
A.
SwitchLinc Dimmer
– Press and hold SwitchLinc Dimmer’s
Paddle Top
for
10 seconds
TWICE
. To confirm that it is in Unlinking Mode, SwitchLinc
Dimmer will flash the light that it is wired to once for each paddle press and
begin blinking the top LED in its LED Bar.
B.
ControLinc
™
Tabletop Controller
– Press and hold the
OFF Button
of the
ON/OFF Button Pair you used for controlling LampLinc Dimmer for 10
seconds. To confirm that it is in Unlinking Mode, ControLinc’s Status LED will
begin blinking.
C.
KeypadLinc
™
– Press and hold for 10 seconds the
Button
you used for
controlling LampLinc Dimmer, then press and hold the same
Button
for 10
seconds
again
. To confirm that it is in Unlinking Mode, KeypadLinc will flash
the light that it is wired to once and begin blinking the ON Button that you
pushed.
D.
Other INSTEON Controllers
– See the INSTEON Controller’s User’s Guide.
2. Press and hold the black
SET Button
on LampLinc Dimmer for 3 seconds. Both the lamp you are
controlling and LampLinc Dimmer’s Status LED will blink to confirm unlinking. Depending on the
INSTEON Controller, you have about 4 minutes to perform this step before Unlinking Mode times out
automatically.