Icon Appliance Adapter User’s Guide
Page 6 of 15
Unlinking ICON Appliance Adapter from an INSTEON Controller
If you are no longer going to use an ICON Appliance Adapter that has previously been linked to an
INSTEON Controller, it is very important that you unlink it, otherwise the controller will retry any
commands intended for the unused module, thus slowing down your system.
1. Select your INSTEON controller from the list below and follow the method shown to put it into
Unlinking Mode
.
A.
ICON Dinner Switch
– Press and hold ICON Dimmer Switch’s
Paddle Top
for 10
seconds
TWICE
. To confirm that it is in Unlinking Mode, ICON Dimmer Switch will
flash the light that it is wired to once for each paddle press and begin blinking its LED.
B.
ICON Tabletop Controller
– Press and hold the
OFF Button
of the ON/OFF Button
Pair you used for controlling ICON Appliance Adapter for 10 seconds. To confirm that
it is in Unlinking Mode, ICON Tabletop Adapters Status LED will begin blinking.
C.
ICON Keypad Dimmer
– Press and hold for 10 seconds the
ON Button
you used for
controlling ICON Appliance Adapter, then press and hold the same
ON Button
for 10
seconds
again
. To confirm that it is in Unlinking Mode, ICON Keypad Dimmer will
flash the light that it is wired to once and begin blinking the ON Button that you
pushed.
D.
Other INSTEON Controllers
– See the INSTEON Controller’s User’s Guide.
2. Press and hold the black
SET Button
on ICON Appliance Adapter
for 3 seconds. The ICON Appliance Adapter’s Status LED will blink
to confirm unlinking. Depending on the INSTEON Controller, you
have about 4 minutes to perform this step before Unlinking Mode
times out automatically.