NX5760M3 Computer Blade Server
39
non-electric state. Please solve according to the following steps:
1. Check whether your power socket can supply power normally and power cable is connected
correctly or not.
2. Press the power switch for many times to start (pay attention not to exert too large force
from your finger)
3. Disconnect the power cable of the system and open the case to check.
4. Check the fastness of the cable connection in the case and accessory plugging.
5. Remove other external components than Inspur ones.
6. Pack the case, connect the power cable correctly and start the machine.
5.2.2
Display doesn’t work
It can be electrified (the host can start and run normally), but the display doesn’t work:
1. Check the correctness and fastness of the signal cable and power cable of the display.
2. Make sure to power on the display
3. Adjust the contrast and brightness of the display and determine whether it can display or
not.
4. Shut down the system and disconnect the power cable to check whether there is curve in the
pin at the connecting end of the display signal cable and host.
5. Replace another display for test if possible.
6. If the machine is installed with other components than Inspur ones. Please remove it first.
7. With the permission of Inspur technical support personnel, pull and plug RAM and clear
CMOS for test.
5.2.3
Installation system can’t find the hard disk
1. When install the system directly booted with the system CD, if it prompts that no hard disk
can be found, please pay attention to the normality of the disk state and power-on self-check hard
disk state.
2. If the power-on self check can detect the hard disk but the hard disk can’t be detected when
installing the system, it may be caused by the following several conditions:
●
When use Jierui management software CD to install system, if “No matched storage
controller” is prompted after entering navigation number and system installation information,
please confirm whether navigation number is input correctly.
●
Because the navigation serial number is different when storage configuration has been