50
4.4.12
Processor and Heatsink Module (PHM)
Replacement
To avoid damage to the processor and system board, only authorized
personnel should attempt to replace or install the processor in this server.
To help avoid damage to the processor and motherboard, do not install the
processor without using the processor installation tool.
To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part
number.
To install a faster processor, update the system ROM before installing.
To remove the PHM:
The heatsink may be hot after the system has been powered down. Allow the
heatsink to cool down for a few minutes before removing it.
1.
Remove the access panel (Refer to Access Panel Replacement).
2.
Remove the air duct (Refer to Air Duct Replacement).
3.
Remove the crossbar (Refer to Crossbar Replacement).
4.
Use a T30 Torx Screwdriver to loosen the four screws securing the Processor
Heatsink Module (PHM) to the CPU socket anticlockwise in the sequence as shown
on the heatsink label.
