![background image](http://html.mh-extra.com/html/insportline/in-6937-aluvis/in-6937-aluvis_user-manual_2069342017.webp)
15
Step 2.
After loosening the screws, lift up the running belt and clean in-between the running board. Squeeze the
small white bottle of SILICONE oil which was supplied with your purchase and wipe it evenly across the board.
Step 3.
After lubricating the board, screw the belt tension back to its correct tension. Tighten evenly on both
sides. When it is almost tensioned, run the treadmill at 1km without any load. Adjust both tension screws to
make the belt in the centre of the back roller. Run the treadmill at 5km for 3mins.
Step 4.
Stop the treadmill and start to walk on it at 5km/h. Lastly fine tension both screws until it’s running
smoothly with your weight on.
CLEANING
a)
Please power off and pull the plug out before cleaning.
b)
Wipe out the dust stuck on the surface and running board frequently.
c)
Please clean the surface of frame and running belt with a soft cloth dipped with suds, don’t use things
like eradicator and naphtha. (After cleaning, please dry it for use)
d)
Please take the protecting cover off every two month, use vacuum dust-collector to suck the dust
remaining inside of the protecting cover. (The dust will make the components of circuitry board short
circuit)
CAUTIONS, DEPOSITING
Cautions
Please make sure that the plug has been pulled out before cleaning or maintenance.
Depositing
The treadmill should be deposited indoor in case of being damp. Water can’t be spattered and nothing can be laid
and inserted on the treadmill.
Please keep the air a little humid in winter. And please void the big static electricity, it may disturb the operation
of meters or even damage them.
GUIDES FOR MALFUNCTION
Analyzing and eliminating malfunction
Item.
Malfunction
Reasons
Solution
1
Treadmill can’t be
started
The safe key isn’t in the right
position
Put the safe key in the right
position.
The electrical switch is placed to “0”
Turn the electrical switch to “1”.
2
Meter can’t display
The meter and upper communication
line are not connected well
Disassembly meter and check the
upper communication line, make
sure that meter and communication
line are connected well.
The upper communication is broken
Replace it!