16
3
Heart rate can’t be
displayed
The pole of heart rate sensor is not
wet enough
Wet the pole with water or liquor
for hard contact lenses.
Disturbed by electromagnetism
Stay away from electromagnetism.
4
Incline doesn’t work
The motor wire is not well connected Open the motor cover and
reconnect it.
5
Running belt runs
faster or slower than
what has been
displayed
Unadjusted
Readjust it.
6
Running belt slips
Running belt is not tight enough
Please read point “Maintenance:
The adjustment steps for poly V-
belt/running belt” for reference.
7
Running belt is
deflected
The running belt is unadjusted
Please read point “Maintenance:
The adjustment steps for running
belt deflection” for reference.
8
Displayed E0 on the
screen
Safety key problem
Check the safety key or Reed pipe
for safety key.
9
Displayed E01 on the
screen
No sensor signal
Check sensor wire, whether it is
been connected well or whether it is
broken.
10
Displayed E02 on the
screen
The PCB problem
Change the PCB.
11
Displayed E03 on the
screen
The speed problem
If find it when speed is exceed
8km/h, it is overweight or the
broken of running board, running
belt. Check the running board and
running belt. If it is the problem of
running belt, try to add some oil for
the running belt at first.
If speed is not exceed 8km/h,
change motor or PCB to check.
12
Displayed E04 on the
screen
Communication lines problem
Check the connect of upper
communication line with console
board and lower communication
line with PCB, the connect of upper
communication line and lower
communication line. If they are
connected well, change the
communication lines.
13
Displayed E05 on the
screen
Over current protection
Check whether it is overloading
Check whether the drive motor can
run normally. If not, replace motor.
Check PCB, if it is broken, replace
PCB.
Check power voltage, use normal
power voltage.
14
Displayed E06 on the
screen
The motor problem
Check those in turn: whether the
motor wires are connected; change
motor; change PCB.
