60
“
A
SSEMBLY
I
NSTRUCTIONS
”
S
TEP
2
–
Handrail Assembly
NOTE:
Two pcs
Nylock Nuts (M10xp1.5)(115)
will be pre-attached on each side of the Upper
Upright Post Assembly ; Total four pcs Nylock Nuts (115) will be pre-attached.
a. Remove two pcs
Nylock Nuts (M10xp1.5)(115)
from the right side of the
Upright Post
Assembly.
b. Attach the
Handrail Assembly (9)
to the
Main Frame Assembly (2)
by tightly securing
with 3pcs
Nylock Nuts (M10xp1.5)(115)
and
1pcs Bolt (M10x65mm)(105).
c. Slide the
Upright Sleeve (38)
down until it meets the
Upper Motor Cover (22).
d. Follow the
FIG. A
, start fully tightening
2pcs Lock Washers (M10)(75)
,
2pcs Bolts
(M10x20mm)(102)
and
2pcs Nylon Nuts (M10xp1.5)(115)
that connecting to
Upright
Post Assembly
and
Main Frame.
e. Repeat the above same procedures on the left side.
S
TEP
3
–
Motor Cover & Wires Assembly
g. Attach the
Right Side Motor Cover (36)
to the
Main Frame Assembly (2)
by securing
5pcs Bolt (M5x15mm)(88)
.
h. Repeat above same procedures on the left side.
i.
Connect the
Middle Motor Connection Wire (121)
to the
Rear Motor Connection Wire (122)
.
j.
Connect the
Middle Connection Wire (118)
to the
Rear Connection Wire (119)
.
Be care not to pinch the wires.
k.
Move the
Right Upright Decoration Cover (40)
upward and gently insert the
Right Upright Decoration Cover (40)
into the recesses located on the back of the
Handrail Assembly (9)
.
l.
Repeat the above same procedures on the left side.
**Make sure the above parts are tightened before moving on to the next page**
FIG. A
Summary of Contents for IN 2440
