- 36 -
Quick setup
Set DO function
F5-01
FM function selection
2
2 (Fault output)
0: No output
1: AC Drive running
2: Fault output
36: Software current limit exceeded
42: Brake output
43: MC (Magnetic contactor) output
Setting range: 0 to 59
NOTE:
This signal goes to magnetic contactor.
F5-02
Relay function selection (TA/TB/TC)
43
43 (MC)
Setting range: same as FM
NOTE:
This signal goes to magnetic controller.
F5-03
Relay function selection (PA/PB/PC)
42
42 (Brake)
Setting range: same as FM
NOTE:
This signal goes to brake contactor.
Set magnetic
contactor
F8-60
Drive run delay ON set time
0.20
0.20
0.20 to 10.00s
NOTE:
If MC is controlled by elevator controller, then F8-60 is useless.
F8-61
MC contactor delay OFF set time
0.20
0.20
0.00 to 10.00s
NOTE:
If MC is controlled by elevator controller, then F8-61 is useless.
Set brake contactor
F8-55
Brake release current threshold
20
20
0 to 200%
F8-56
Brake release frequency threshold
0.20
0.20
0.00 to 25.00 Hz
F8-57
Brake release delay ON set time
0.0
0.0
0.0 to 5.0s
F8-58
Brake apply frequency threshold
0.5
0.5
0.00 to 25.00 Hz
F8-59
Brake apply delay OFF set time
0.2
0.2
0.0 to 5.0s
CONTINUE
