- 35 -
Quick setup
Set DI function
F4-00
DI1 function selection
1
1 (Forward run)
0: No function
1: Forward RUN (FWD)
2: Reverse RUN (REV)
8: IGBT enable
9: Fault reset (RESET)
12: Multi-reference terminal 1
13: Multi-reference terminal 2
14: Multi-reference terminal 3
Setting range: 0 to 59
NOTE:
This signal comes from elevator controller.
F4-01
DI2 function selection
2
2 (Reverse run)
Setting range: same as DI1
NOTE:
This signal comes from elevator controller.
F4-02
DI3 function selection
12
12
Setting range same as DI1
NOTE:
If analog input is used as frequency reference, then DI3 is useless,
just leave it alone. If multi-reference is used as frequency reference,
then signal 'nominal speed' comes from elevator controller.
F4-03
DI4 function selection
13
13
Setting range: same as DI1
NOTE:
If analog input is used as frequency reference, then DI4 is useless,
just leave it alone. If multi-reference is used as frequency reference,
then signal 'creep speed' comes from elevator controller.
F4-04
DI5 function selection
14
14
Setting range: same as DI1
NOTE:
If analog input is used as frequency reference, then DI5 is useless,
just leave it alone. If multi-reference is used as frequency reference,
then signal 'inspection speed' comes from elevator controller.
F4-05
DI6 function selection
0
-
Setting range: same as DI1
CONTINUE
