27
How to use INO SECURE Tronic, prepairs:
-attack the machine on the tractor properly
- connect hydraulic pipes and electric cables
- Switch on INO SECURE Tronic
- check with lifting and lowering if hydraulic system is working properly.
PTO drive must be disconnected during testing
. Repeat this operation
twice to exclude eventual air bubbles in the hydraulic system.
- Put the machine with PTO shafts into the horisontal posiion.
Check INO SECURE Tronic device, TEST 1:
-
Switch OFF INO SECURE Tronic device (pull it out from the plug)
-
Start the PTO drive and try to lift both wings into the transport
position.
-
Device is working if wings can not be lifted into the transport
position.
-
If both wings are lifting, device is not working, STOP the operation
immediatelly.
-
If device is working, continue with TEST 2.
Chek INO SECURE Tronic device, TEST 2:
-
Switch ON a device
-
Start PTO drive and slowly lift one of both wings.
-
Minimise rpm as much as possible. Lifting must be stopped
automatically at too big angle.
-
Do the same procedure for the second wing.
-
If both wings are stopped, a device is working properly.
What to do in the case that INO SECURE Tronic is not working:
When it is not possible to lift wings into the transprot position due to
the mistake on the INO SECURE Tronic, deblockade electromagnetic valves
with loosening the bolt,
Fig
.20. After that working with the machine is not
allowed.
Summary of Contents for DUPLEX 800
Page 21: ...21 Fig 12 Fig 13 1 2 3 ...
Page 39: ...39 ...
