INNOVATECH PRODUCTS & EQUIPMENT CO., INC.
28
SUPPLEMENTARY INSTRUCTIONS FOR DATSUN FORKLIFTS
“IF THE DATSUN MODEL FORKLIFT YOU ARE CONVERTING FROM GAS TO LP DOES HAVE A
VACUUM SOLENOID WITH THREE HOSES CONNECTING TO IT AND AN ELECTRONIC PULSER
CONNECTED TO THE SOLENOID, THEY BOTH MUST BE REMOVED AND DISCARDED.” THE
LONGER OF THE HOSES IS USED BY CONNECTING THE END TO THE DISTRIBUTOR VACUUM
ADVANCE AND THE OTHER END TO THE LPG CARBURETOR.
SUPPLEMENTARY INSTRUCTIONS
FOR
1982 DATSUN FORKLIFTS
WITH MODEL H20 ENGINE
IF THE ENGINE IS EQUIPPED WITH A FORMED ELBOW TYPE HOSE AT THE TOP OF THE
WATER PUMP, INSTEAD OF A FITTING, YOU MUST CUT THE RUBBER HOSE SO THAT 4”
OF HOSE REMAINS AT THE TOP OF THE WATER PUMP CONNECTION. THE 4” OF HOSE IS
NEEDED TO MAKE YOUR WATER CONNECTION AND TO GAIN PROPER CLEARANCE
BETWEEN THE WATER HOSE AND THE EXHAUST MANIFOLD PIPE.
INSERT HOSE UNION
AND CONNECT THE WATER LINE FROM THE VAPORIZER USING TWO CLAMPS TO
SECURE THEM.
Impco L.P. Gas Kit Installation Instructions
DATSUN
C 4000, 5000, 6000
P 4000, 5000, 6000
H-20 Engine
The following instructions give a general outline of installation procedures on converting Industrial Trucks to
LP gas operation. They are supported with additional sheets, including drawings where applicable.
These instructions are brief for simplicity and we recommend that installation and service personnel be aware
of safety regulations as outlined in the national Fire Protection Association pamphlets 58, 37, and 505. There
