5
wire is not being used isolate and tape it out of the way. The default
analog output configuration is 0V = 7.35 AFR and 5V = 22.39 AFR.
5
The
PURPLE
wire can be connected to a tach signal to log engine
RPM, use the shift light, PowerSafe operation, and window switch. A
tach signal can be acquired from the negative lead of a coil, ECU,
negative lead of an injector, or directly from the ignition box if running a
multi-spark (i.e. MSD 6AL).
Note:
A tach signal can not be acquired from the negative lead of the coil
on vehicles running CDI ignitions. For these applications use the
negative lead of an injector or a tach adapter (if available for your model
ignition).
2.1.1
Single Innovate Device Relay Wiring Instructions
The relay diagram below is intended for use to power the gauge,
it is not for the PowerSafe relay’s operation.
2.2
Gauge Mounting and Routing
The PSN-1 gauge fits in any standard 2 1/16” (52mm) gauge pod. Mounting
of the gauge should be done in such a manner that the cables are not being
