10
PSN-1
Setup
3
3.1
Entering Setup Configuration
The PSN-1 can be configured directly from the gauge itself or by connecting
it to a computer with the LM Programmer software.
3.1.1
Configuration using PSN-1’s interface buttons
1.
From the main screen, press and HOLD the left interface button to
put the gauge in setup mode
2.
Pressing either the left or right interface buttons will allow you to
cycle through the 10 different setup parameters in the menu.
3.
Once the desired setup parameter is displayed, press and HOLD the
left interface button to make a change. Once the parameter’s
configuration has been entered it will start flashing.
4.
Make changes by using the left or right interface buttons.
5.
Once in setup mode, pressing and HOLDING both interface buttons
together will move you to the main screen. The gauge will revert back
to the main screen if no there have been no button presses for 15
seconds.
3.1.2
Configuration using the LM Programmer software
Refer to chapter 4, Logworks 3 & LM Programmer Software Package to gain
access to the software.
1.
Connect the OUT port of the PSN-1 to the provided serial
programming cable. Connect the other end of the serial
programming cable to your computer. If your computer does not
have a serial port, you can purchase a USB to Serial adapter from
Innovate Motorsports (P/N 3733) or use any USB to serial adaptor
that includes drivers. Make sure that nothing is connected to the IN
port of the PSN-1
2.
Power up the PSN-1.
3.
Launch
LM Programmer.
The LM Programmer application can be
launched from
Start->Programs->LogWorks3->LM Programmer
from
the Windows task bar.
