Using the Scan Tool
VIEWING OEM ENHANCED DTCs (Ford/Mazda only)
14
Turn the ignition OFF, then back ON. Choose
Continue
.
Proceed to step
3
.
3.
A “One moment please” message displays while the test is in
progress.
If the Scan Tool fails to link to the vehicle’s computer, a
“Communication Error” message shows.
- Ensure your vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Choose
Relink
to try again, or, choose
System Menu
to
return to the System Menu.
If the Scan Tool
cannot
link to the vehicle’s computer after three
attempts, the message “Contact Technical Support” displays.
- Choose
System Menu
to return to the System Menu.
- Turn the ignition off, and disconnect the Scan Tool.
- Contact Technical Support for assistance.
If the
KOER
Test was selected, and the vehicle’s engine
is not
running, an advisory message shows.
- Start the engine and choose
Relink
to try again, or, choose
System Menu
to return to the System Menu.
If the
KOEO
Test was selected, and the vehicle’s engine
is
running
, an advisory message shows.
- Turn the ignition OFF then back ON and choose
Relink
to try
again, or, choose
System Menu
to return to the System
Menu.
4.
If the
KOER
test was selected, an “instructional” message shows.
Turn the steering wheel to the right, then release.
Press and release the brake pedal.
Cycle the overdrive switch (if equipped).
A “One moment please” message displays while the test is in
progress.
5.
Refer to DISPLAY FUNCTIONS on page 4 for a description of LCD
display elements.
If the definition for the currently displayed code is not
available, an advisory message shows.
I/M MONITOR STATUS icons are not displayed when
viewing enhanced DTCs.