INNO VIEW 5, User Manual

Page: 13 / 52

Chapter 2 Installation 12
•
Users should always wear safety glasses during fiber preparation and splicing
operation. Fiber fragments can be extremely dangerous if they are ingested or
come into contact with eyes, skin.
•
Take out the battery immediately if the followings are observed when using
the splicer:
•
Fumes, bad smell, abnormal noise or over heat.
•
Liquid or other matter falls into cabinet
•
The splicer is damaged or dropped.
Note: If any of these faults occurs, please contact our service center
immediately. Leaving the splicer in a damaged state without any prompt
measures may cause equipment failure, electric shock, or fire and may result in
injury or death.
•
Do not use compressed gas or canned air to clean the splicer. They may contain
flammable materials that could ignite during the electrical discharge.
•
Please use VIEW 5 designed battery only. Using an improper AC power source
may cause fuming, electric shock or equipment damage and may even result in
fire, injury or death.
•
Please use VIEW 5 designed charger only. Do not place any heavy objects on
the AC power cord. Keep the power cord away from heat source. Using an
improper cord or a damaged cord may cause fuming, electric shock or
equipment damage and may even result in fire, injury or death.
Maintenance and external care precautions
•
Always avoid using hard objects to clean V-grooves and electrodes.
•
Always avoid using acetone, thinner, benzol or alcohol when cleaning any parts
of the splicer, except for the places advised.
•
Use a dry cloth to remove dust and dirt from the splicer.
•
If the outside of the splicer is dirty, plunge a soft cloth into diluted neutral
washing up liquid, wring out the cloth and clean. Dry the splicer with a dry cloth
but DO NOT USE furniture polish or other cleaning agents.
•
Always follow the maintenance instructions in this manual.