INMES Industrial Ltda – IM-30 MM
11
6 - INSTALLING AND MANTAINING THE SAW BLADE
Tools needed:
01-
24x27 wrench (supplied with machine)
02-
27 wrench (supplied with machine)
03-
3/16”x4" Phillips (supplied with machine)
You must follow the following steps:
Wear leather gloves when replacing or maintaining the blade.
Remember: Whenever the operator remove the blade for replacement or sharpening, its extremely important
to unplug the power cord from power source.
Once this is done proceed as shown as figure 03, following these steps:
1)
Remove the three bolts
from the yellow plastic
flange, figure 03 (01);
2)
Remove the yellow
plastic flange and the
acrylic blade guard
figure 03 (02);
3)
Insert wrench 1 in the
region A as shown in
figure 03 (06);
4)
Then Using wrench B
turn the blade nut
clockwise, loosen the nut, as shown figure 03 (03);
5)
Rotate the wrench B down;
6)
Rotate the wrench A up;
7)
Remove the nut figure 03 (03);
8)
Take the flange off figure 03 (04);
9)
You are finally ready to remove the blade, figure 03 (05);
Important
Each material that you wish to cut (wood, plastic or
aluminum) requires a specific saw blade.
WARNING
!
Use only blades of 300mm diameter.
DANGER
!
The manufacturer advice do not use either
cracked or welded saw blade.
!
Make sure all safety protection are correctly
installed.
!
After changing or maintaining the blade,
make sure it is well tightened before
starting the machine.
DANGER
!
Do not use high speed steel sawblade
because our sawblades work at a 1200rpm.
