INMES Industrial Ltda – IM-30 MM
12
To replace the blade you must follow these steps:
When installing a blade, make sure the blade is clean and free of any protective coating;
When replacing the blade pay attention to the direction of the blade’s teeth.
Once you have checked all these points, then you will be able to replace the blade, following the respecting
steps:
1)
Blade;
2)
Flange, figure 03 (04);
3)
Nut, figure 03 (04) manually tight to the end;
4)
Insert wrench A in the region A, figure 03 (06);
5)
Then using wrench B turn the blades nut counter clockwise, figure 03 (03);
6)
Make sure the blade is well tight;
7)
Fit the acrylic blade guard item 02, around the blade and right after that fix the yellow plastic flange
with three screws by a Phillips key;
8)
Make sure the flanges are clean and properly arranged;
9)
Lower the blade into the table slot and verify for any contact with the base;
10)
If the blade contacts table, verify all the procedure that you have done, if you still have problem to
adjust your machine contact authorized service.
7. MOUNTING THE IM-30 SPRING
Before beginning working with your IM-30 Plus Rotating Miter
Saw, its necessary to install the spring, which it is already pre-
assembled on the machine.
To mount the spring, remove the bolt fig. 04 (01)
using Allen key 6mm that comes with the machine. Lift the top as
far as possible, using the handle, place the spring in the direction
of the arrow, until you are able to replace bolt in its original hole.
8. OPERATING YOUR IM-30 MM ROTATING MITER SAW
WARNING
!
As soon as you have done, turn off the saw
and unplug the cord power from the out let.
CAUTION
!
Use only saw blades specifically
recommended for wood, plastic, or
aluminum, according to the material you
want to cut.
