EDAM-4200 Series User’s manual Version 1.03
3.3
Status LED indicator for
EDAM-4200
I/O modules
There are Tow flash types of the Status LED indicator on the front panel of EDAM-4200 series.
3.4
Ethernet LED indicator of EDAM-4200
There are two ports of RJ-45 ethernet connector. Each RJ-45 port LEDs built with two indicators to represent the
EDAM-4200 ethernet status as explained below:
♦
Yellow indicator (Speed): This LED is always ON.
♦
Green indicator(Link): This LED is normal on whenever the EDAM-4200 module’s Ethernet
wiring is connected.
3.5
Reset
There is a RESET push button on the front panel. After press the reset button the module will be rebooted.
3.6
I/O modules wiring
The system uses a plug-in screw terminal block for the interface between I/O modules and field devices. The
following information must be considered when connecting electrical devices to I/O modules. The terminal block
accepts wires from # 14 AWG ~ 28 AWG. Always use a continuous length of wire. Do not combine wires to make
them longer.
1. Insert the screw driver into the left hole of the terminal.
2. Insert the wiring into the left hole of the terminal.
No.
Color
LED Status Definition
1
Yellow (Power-LED)
On
Power-LED, Always ON.
2
Green (LINK-LED)
On
(LINK) This LED is normal on whenever the
EDAM-4200 module’s Ethernet wiring is connected
3
Green (LINK-LED)
Blinking
(COM) Blinks whenever EDAM-4200 module is
transmitting or receiving data(I/O command) via
Ethernet.
Printed Date: 27 February 2018
23