48
Using the system
Centrali anti-intrusione
5-19-2
User to panel calls
If the “Answerphone” function (refer to paragraph 5-4 Activations) is enabled, users can
call the control panel from any remote telephone and send commands to the system
(refer to paragraph 3-2 Shortcut with code) and/or activate Listen-in sessions (refer to
paragraph 5-17 Listen-in) in the following way.
1. Dial the control panel telephone number.
2. Allow the phone to ring for the pre-established number of rings. The control panel
will answer and will play message n.216.
3. Type in your PIN followed by “#”.
4. The control panel will activate the voice function which will announce the avail-
able shortcuts and the number keys to press.
5. As soon as the selected number is pressed on the telephone keypad, the control panel
will activate the corresponding shortcut.
If the system is equipped with a Nexus dialler, the user can operate on the control panel
via voice call to the SIM card of the Nexus. If duly configured (by the installer), the user
will receive feedback (SMS text message or ring) from the Nexus relating to
successfully implemented commands.
5-19-3
SMS text message to
the user
If the system is equipped with a duly programmed Nexus dialler, the user may receive
SMS text messages signalling that events have occurred.
If an event (which has been duly configured by the installer) occurs or restores, the
control panel will send notification to the programmed users via SMS.
5-19-4
SMS text message to
the control panel
If the system is equipped with a duly programmed Nexus dialler, the user can operate
on the control panel by sending SMS text commands to SIM card of the Nexus.
Users who wish to activate a command via SMS text must enter the command details as
follows:
<xxxxxx> <SMS Text>
where:
• <xxxxxx> stands for the PIN of a control panel user
• a blank space must be keyed in after PIN entry
• <SMS Text> which is the command identifier - this parameter must be provided by
your installer.
If duly configured (by the installer), the user will receive feedback (SMS text message
or ring) from the Nexus relating to successfully implemented commands.
SMS TEXT AT DEFAULT
The SmartLiving control panel is programmed with five predefined default commands:
• Balance enquiry relating to the SIM card of the Nexus
If the following SMS text message is sent:
<xxxxxx> CREDIT BALANCE
where <xxxxxx> stands for the user's PIN - the user will receive an SMS text
message indicating the remaining credit (balance).
• Status enquiry relating to the Nexus
If the following SMS text message is sent:
<xxxxxx> STATUS
where <xxxxxx> stands for the user-access PIN - the user will receive an SMS text
message indicating the:
•• device name and firmware revision
•• GSM network provider
•• GSM signal reception level
•• device tamper status
•• BUS status
•• Balance (remaining credit)
• Inhibition (using the “EXC” or “ESC” command) or activation (using the “INC”
command) of the control panel zones
If the following SMS text message is sent:
