27
Static IP: enables or disables the use of a static IP address. If you select this
option, specify an IP address manually. Then, the gateway obtains the specified
static IP address every time it dials up to a network.
Connection Mode
o
Always Online: indicates that the gateway stays online when it is running
properly and will be disconnected and redial up only if the dial-up interface
does not transmit any traffic in 30 minutes. This is the default connection
mode of the system.
o
On-demand Dial
•
Data Trigger: indicates that the gateway is offline by default and will dial up
automatically when data is sent to the Internet.
o
Manual Dial: indicates that the network connection can be established or
terminated by clicking
Connect
or
Disconnect
in the
Status
area.
Redial Interval: specifies the period that the gateway waits before dialing up
again.
ICMP Probes
o
ICMP Detection Server: specifies the IP address or domain name of the
remote ICMP server to be probed. (If two ICMP servers are enabled, it is
recommended that you enter the IP addresses or domain names of both
servers here.) The gateway supports two ICMP servers: a primary server and
Summary of Contents for InGateway502
