11
10
Insert the plug on the end of the flat cable in the socket of
the on-off switch (
5
). Push the plug firmly into place until
you hear a definite click.
6
Attach the LED film to the hook on the second telescope
rod.
Follow the same procedure for the second LED film, en-
suring that the short flat cable is on the same side as the
on-off switch. To connect the second film, push the protective
sleeve (
9
) on the long cable downwards,
9
and plug the
contact pins (
10
) into the sockets (
11
) on the second film.
Ensure that the pins are firmly plugged into the sockets.
10
Secure the corners of the two LED films with the silicone
stoppers (
6
) provided.
7
Connect the lamp cable (
7
) to the plug (
8
) and insert the
plug in the mains socket.
8
On-off switch and dimmer
To switch the lamp on or off, press the switch (
12
) on the
telescope rod. The indicator light turns orange when the
lamp is switched on.
11
To dim the light, touch the lightning symbol on the LED film
until the brightness reaches the desired level. The light will
flash briefly when maximum brightness is reached.
12
Version 2:
The LED films can be dimmed individually by
briefly touching the lightning symbol.
Adjusting the position of the lamp
The ball joints allow for adjustment within a limited range.
Important:
Do not tilt the telescope rods too far, as this
will place a strain on the LED films.
Cleaning
The lamp can be cleaned with a dry, lint-free cloth or a
feather duster.
Important:
Any contact with cleaning fluids or sprays can
damage the LEDs!
Technical specification
110-230 V, 50/60 Hz.
The lamp has a wide-range input power
supply for operation with 230 V or 125 V.
Secondary 48 V DC,
electronic ballast with plug.
Version 1:
1 transparent plastic film with 1500 integrated
LEDs, 23 W, 2600 lm, 3000 K, CRI 90.
Version 2:
2 transparent plastic films, each with 1500 inte-
grated LEDs, 2 x 23 W, 2600 lm each, 3000 K,
CRI 90.
A
The LEDs in this lamp meet the requirements of
energy efficiency class A.
The LED films can be replaced, if necessary, by the user.
According to the manufacturer, LEDs of this class have an
average life of 50 000 to 60 000 hours.
Any repairs that may become necessary must be carried
out by a qualified electrician. In the event of damage to the
power cord, replacements may only be fitted by Ingo Maurer
GmbH.
English
English
Summary of Contents for DEW DROPS FLOOR
Page 13: ...23 22 6 5 2 4 2 5 7 8 6 7 8...
